Hello All,
is there a rule to choose the right drill bit for pre drilling and countersink?
It's annoying to always put a drill bit in the drill, than swap it for the little
bit to countersink and than put the scew in.
So I wanted to by one of those bits that do both pre drilling and countersink in one,
however this means I would have to buy multiple size depending what crew I need,
so I was wondering if there is a rule for it or can I use a 3mm drill bit or something similar
everytime independently on the screw size?
Thanks
is there a rule to choose the right drill bit for pre drilling and countersink?
It's annoying to always put a drill bit in the drill, than swap it for the little
bit to countersink and than put the scew in.
So I wanted to by one of those bits that do both pre drilling and countersink in one,
however this means I would have to buy multiple size depending what crew I need,
so I was wondering if there is a rule for it or can I use a 3mm drill bit or something similar
everytime independently on the screw size?
Thanks